|
|
Radio System FAQ
What are cross trims? Why does the trim beside the throttle adjust the elevator and vice versa?
The default setting on the 9Z is for cross trims, which means the trim next to the throttle adjusts the elevator and the trim next to the elevator adjusts the throttle. This is an excellent set- up option because this way the modeler can adjust the elevator trim with the left-hand while the right hand is holding the necessary elevator inputs. However, if you prefer "conventional trims," you can reverse the cross trim set-up in each model as follows (note that you must adjust this in each model memory and any time you completely reset a model):
| Reset the Cross Trims to Same Side Trims: |
Open Function (FNC) and Reassign the Elevator and Throttle Trims: |
P B K O F Q G O G Q H N R |
| Reset the Trim Type to Operate Properly for Throttle and Elevator: |
E G E N F F N N |
Back to main FAQ/Contact Info page
|
|
