|
|
Radio System FAQ
I am setting up an Ultra Stick with my 9C radio. All of your current FAQ's only tell me how to set this up only with a Y-harness for the elevator servos, but I want to use the Ailvator function, with two separate elevator servos so that I can use them separately also. Can I do this?
Yes, you can definitely do this. What you would need to do is set your radio in Acro Mode, with Flaperon, Ailvator and Airbrake active.
- Your channel set up will be as follows:
- Channel 1- Right Aileron
- Channel 2- Right Elevator
- Channel 3- Throttle
- Channel 4- Rudder
- Channel 5- Right Flap
- Channel 6- Left Aileron
- Channel 7- Left Flap
- Channel 8- Left Elevator
- You will want to go into Aux Channel and assign VR-E to channel 7.
- You will need to set up the following:
- Program Mix 1- Master will be Aux 1- slave will be Gear, Link will be OFF, Position will be NULL
- Program Mix 2- Master will be Aile- slave will be Aux 1, Trim will be ON, make the Switch "C" in the UP Position.
- Program Mix 3- Master will be Aile- slave will be Gear-, Link will be OFF, Trim will be On, make the Switch "C" in the UP Position.
- Program Mix 4- Master will be Aux 1- slave will be Aux 1, Link will be ON, make the Switch "C" in the UP & CENTER Position, Rate will need to be: Left -100%, Right -100% with 0% Offset.
- Program Mix 5- Master will be Gear- slave will be Gear, Link will be OFF, make the Switch "C" in the UP & CENTER Position, Rate will need to be: Left -100%, Right -100% with 0% Offset.
- Now you will want to go back into Aux Channel and make channel 5 NULL.
This should get you the setup that you are looking for.
Back to main FAQ/Contact Info page
|
|
