|
How can I set up V-Tail mixing and still have a steerable nosewheel that does NOT respond to the elevator input?
To do this with the 6X, you will need to use both available mixes and channels 1-4 and 6. Plug the nose gear steering servo into channel 6, and all other hook ups as normal, and program the radio for V-tail. Note: If you want the channel 6 knob to remain active as a steering trim, do not do the second mix listed below. Remember that the Ele DR switch on the front of the radio MUST remain in the 'on' (down) position for these mixes to work.
| Objective | Steps | Keystrokes |
|---|
| Pmix channel 4 (rudder) to channel 6 (nose gear), +100% each way | Open the programming menu | Both Mode Keys together |
| Select PMIX 1 | Arrow Up to PMX1 |
| Make it active | Cursor over until INH blinks press + |
| Master Channel 4 | Cursor over once, press + key until top triangle points at 4 |
| Slave Channel 6 | Cursor over once, press + key until bottom triangle points at 6 |
| Make The Mix Positive | Cursor over once, Press + key until + flashes |
| Set 100% | Move Rudder Left, then Cursor over once, press + key until 100 displayed. Move Rudder Right, then press + key until 100 displayed |
| Pmix channel 6 to channel 6 -100% each way to disable knob | Select PMIX2 | Arrow up to PMX 2 |
| Make it active | cursor over until INH blinks press + |
| Master Channel 6 | Cursor over once, press + key until top triangle points at 6 |
| Slave Channel 6 | Cursor over once, press + key until bottom triangle points at 6 |
| Make The Mix Negative | Cursor over once, Press - key until - flashes |
| Set 100% | Move Ch 6 Knob Left, then Cursor over once, press + key until 100 displayed. Move Ch 6 Knob Right, then press + key until 100 displayed |
Back to main FAQ/Contact Info page
|
